Agri l-walls
AGRI L-WALLS FOR MAIZE AND GRASS PRESERVATION
AGRI L-WALLS, 7 - 10 - 15 AND 20 TON AXLE LOAD
PRECAST CONCRETE RETAINING WALL FOR TRENCH SILOS - SINGLE-LOADED
• Measuring and fitting possible
• Length adjustment
• With bevel
• Modification for corner formation
Upon request, Inox corn brackets can be provided in the wall for the use of tension straps.
AGRI L-WALLS FREESTANDING 7 TONS - 10 TONS AXLE LOAD WITH EARTH WALL
AGRI L-WALLS FREESTANDING 10 TONS - 15 TONS AXLE LOAD WITH EARTH WALL
AGRI L-WALLS FREESTANDING 15 TONS - 20 TONS AXLE LOAD WITH EARTH WALL
AGRI L-WALLS FREESTANDING 15 TONS AXLE LOAD
AGRI L-WALLS FREESTANDING 20 TONS AXLE LOAD
MODIFIED/ ADDITIONAL ELEMENTS
Agri L-corner section
With bevel
2-piece corners
Freestanding
Axle loads outer L-walls | |
---|---|
PRODUCT | FREESTANDING |
CLF10AM | 7 ton |
CLF10A | 10 ton |
CLAGRI | 15 ton |
DLAGRI | 20 ton |
With earth wall
Axle loads outer L-walls | |
---|---|
PRODUCT | WITH EARTH WALL |
CLF10AM | 10 ton |
CLF10A | 15 ton |
CLAGRI | 20 ton |
DLAGRI | 20 ton |
Axle load
The axle load is calculated by dividing the mass of the compactor by the number of axles (so usually by 2). At CBS Beton, all walls are calculated with an edge clearance of 0 cm so that you can drive over the full width of your silo. Here, CBS Beton meets the strictest standards.
When choosing your new silo, it is very important to check both the axle load and the edge clearance. The use of tandem and tridem combinations requires a special calculation. If you want to drive these machines to the edge, it is best to contact our engineering office.
An edge distance of 0 cm!
Our silo walls are designed so you can be drive right up to the edge. This allows the entire width of the silo to be used to compact the silage. This is the best way to preserve your silage.
TYPES OF LIFTING HOOKS
The following lifting hooks are required to move the walls.
See technical sheet for lifting hooks needed for different types of walls.
Ball head anchors (1) = KKA
Ring transport anchors (2) = RTA
PVC BATTENS
PVC battens of 3 cm are placed between the walls. Advantages are: they will not crack or splinter, in addition, the battens do not absorb moisture and cannot rot. They retain their mechanical properties at temperatures between -18 and + 50 degrees Celsius.
To use less Sikaflex, foam joints are also placed between the high walls to reduce the cost.
SEALING
SIKAFLEX
For walls placed side by side, we apply a Sikaflex joint sealant with a filler gun. The installer applies Sikaflex to each side of the wall to create a strong joint. This is called sealant.
CBS Beton can supply the backfill strips, foam joints, joint gun and Sikaf- lex joint sealant.