AGRI T-WALLS FOR MAIZE AND GRASS PRESERVATION
AGRI T-WALLS 7 - 10 - 15 and 20 TON AXLE LOAD
PRECAST CONCRETE RETAINING WALL FOR TRENCH SILOS - DOUBLE LOADED
- Measuring and fitting possible
- Length adjustment
- - The top of the wall is rounded
- Optimal wall/floor connection for silage in and out
For those looking for a partition wall with an emphasis on the budgetary and space-saving aspect, a T-WALL is an ideal solution as a double-loaded wall. For an angled connection to another wall, part of the base is cut out.
Upon request, Inox corn brackets can be provided in the wall for the use of tension straps.
AGRI T-walls 7 Tons Axle Load
AGRI T-walls 10 Tons Axle Load
AGRI T-walls 15 Tons Axle load
AGRI T-walls 20 Tons Axle load
slide-on T (for corner)
|Axle loads partitions T
The axle load is calculated by dividing the mass of the compactor by the number of axles (so usually by 2). At CBS Beton, all walls are calculated with an edge clearance of 0 cm so that you can drive over the full width of your silo. Here, CBS Beton meets the strictest standards. When choosing your new silo, it is very important to check both the axle load and the edge clearance. The use of tandem and tridem combinations requires a special calculation. If you want to drive these machines to the edge, it is best to contact our engineering office.
An edge distance of 0 cm!
Our silo walls are designed so you can be drive right up to the edge. This allows the entire width of the silo to be used to compact the silage. This is the best way to preserve your silage.
TYPES OF LIFTING HOOKS
The following lifting hooks are required to move the walls.
See technical sheet for lifting hooks needed for different types of walls.
Ball head anchors (1) = KKA
Ring transport anchors (2) = RTA
PVC battens of 3 cm are placed between the walls. Advantages are: they will not crack or splinter, in addition, the battens do not absorb moisture and cannot rot. They retain their mechanical properties at temperatures between -18 and + 50 degrees Celsius.
To use less Sikaflex, foam joints are also placed between the high walls to reduce the cost.
For walls placed side by side, we apply a Sikaflex joint sealant with a filler gun. The installer applies Sikaflex to each side of the wall to create a strong joint. This is called sealant.
CBS Beton can supply the backfill strips, foam joints, joint gun and Sikaf- lex joint sealant.